กก
Product model specifications
Wooden sound-absorbing panels composed of decorative, core material and
sound-absorbing mat. Core material for the import of MDF or 18mm thick
16mm sheet. The core material is adhered finishes, pasted on the back of
the Freudenberg black sound-absorbing mat. According to the requirements
of customers, there are a variety of decorative wood veneer, imported
paint, paint and other baked surface finishes.
Two. Accessories for mounting
Three. Preparation before installation
In order to design effect, prior to the installation of sound-absorbing
panels, must complete the following preparations:
Installation place
(1) the installation place must be dry, the minimum temperature is not
less than 10 degrees celsius.
(2) the maximum humidity change of the installation place should be
controlled in the range of 40% ~ 60%.
(3) at least 24 hours before installation, the installation site must
meet the above requirements.
Acoustic panel
(1) check sound-absorbing plate type, size and number.
(2) board must be placed in 48 hours to be installed in places, in order
to adapt to the indoor environment and setting sound absorption board.
keel
(1) board covered wall keel must be installed according to design
drawings and construction drawings requirements, and the keel for
leveling treatment. Keel surface should be flat, smooth, no rust, no
deformation.
(2) the structure of wall to carry on the construction according to the
building code before treatment, the size of the keel must be arranged
arrangement and sound-absorbing panels to adapt. Wood keel spacing
should be less than 300mm, light steel keel spacing is not greater than
400mm. The keel should be installed vertically with sound-absorbing
plate in the length direction.
(3) the distance from the surface of the wood keel to the basic level is
in accordance with the specific requirements, generally 50mm. Long bone
side surface flatness and verticality error should be less than 0.5mm.
(4) keel gap with fillings, should be installed according to the design
requirements, and ensure that does not affect the sound-absorbing board
installation.
Four. Installation
Measurement of wall size, confirm the installation position, determine
the horizontal and vertical lines, set aside the tangent space size wire
socket, pipe and other objects of the.
According to the construction site of the actual size calculation and
cut part (sound-absorbing board opposite symmetry requirements, with
particular attention to cut part of the sound absorption plate size,
guarantee on both sides of the symmetrical) and lines (edge lines,
lines, lines, connecting corners) and wire socket, pipe and other
objects for the tangent space.
The installation of sound-absorbing plates:
(1) the installation sequence of sound-absorbing panels, follow from
left to right, from the bottom to the top of the principle.
(2) the transverse acoustical tile, notch upwards; vertical
installation, the notch on the right side.
(3) part of wood sound-absorbing panels on design requirements, each
should be carried out in accordance with the order from small to large
facade sound-absorbing board pre-set number of installation. (the number
of digital acoustic panels follow from left to right, from top to bottom
in turn, from small to large)
Fixed on the keel of the sound-absorbing board:
(1) wooden keel: installation with nail
Along the groove and groove plate with nail sound-absorbing board fixed
on the keel, the nail must be above 2/3 embedded wood keel, nail should
be evenly distributed, and require a certain density, each
sound-absorbing plate and keel nail on each node number not less than
10.The transverse installation of sound-absorbing panels, notch upwards
and mounting fitting for each installation, sound-absorbing panels which
are connected in sequence.
The sound-absorbing plate is vertically arranged, the notch on the right
side, then start the installation in the same way from the left. Two
pieces of sound-absorbing plate end to gap set aside not less than 3mm..
กก